Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Prime Infrastructure 2.0 sh commands.

                   I have installed cisco Prime infrastructure 2.0, I an not able to deploy any show commands from PI 2.0.

According to following link show command is not supported in PI 2.0.

http://www.cisco.com/en/US/docs/net_mgmt/prime/infrastructure/2.0/user/guide/create_temps.html

How to take output of any show command from PI 2.0

Need assistance for the same.

1 REPLY
New Member

Prime Infrastructure 2.0 sh commands.

Hello Yusuf,

I believe 'show commands' not supported only refers for 'creating autonomous AP configuration templates' on that link.

For 'show commands' on PI 2.0, please check the following link,

http://www.cisco.com/en/US/docs/wireless/prime_infrastructure/2.0/command/reference/cli20_appendix_011.html#wp2347496727

http://www.cisco.com/en/US/docs/wireless/prime_infrastructure/2.0/command/reference/cli20_preface_00.html

257
Views
0
Helpful
1
Replies