Prime Infrastructure 2: Device Typ not updated after replacement in Device Work Center
I've found something confusing. Please have a look below. Has anyone the same feature or is familiar with that?
We replaced a 4400-series WLAN controller with a 5500 series controller, the UDI information was discovered correctly but the general information was not updated.
I got it uptodate while exporting exporting the device and doing a bulk import. I also recognized that the credentials were not the correct ones for the new controller. Could it be that the credetial mismatch was cause? Is snmp access not enough to update the inventory information?
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...