Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Prime Infrastructure: command to change standalone server to secondary server (for HA)

Primes are supposed to be installed in 2 different servers: 1 primary, 1 secondary for redundancy.

However, the second Prime was accidentally installed as a stand alone server. Hence, it could not register with the primary one.

May I know if there is any way or any command to switch the second Prime from stand alone to secondary in HA mode. Or I need to reinstall Prime from the OVA file?

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

The supported method is to

The supported method is to specify the role during installation. (Reference)

You might be able to re-initialize the db and re-run setup but I would strongly advise restarting with a clean installation to maximize your probability of success.

1 REPLY
Hall of Fame Super Silver

The supported method is to

The supported method is to specify the role during installation. (Reference)

You might be able to re-initialize the db and re-run setup but I would strongly advise restarting with a clean installation to maximize your probability of success.

287
Views
5
Helpful
1
Replies