Prime Infrastructure delegate specific config changes - wireless controller
I have a customer that would like to delegate control for two items on a WLC to a sub-group within their organization. They'd like to allow this group to change the PSK on a specific WLAN on their WLC 5508 and also add/remove/change mac addresses from the Mac Filter list whenever necessary.
They'd like to restrict the group to only be able to make these two specific changes and not be able to change anything else on the controller. Is there a way in PI to restrict this group so that they can only make these changes?
I can see that in 2.0 I can require job approval which may work as some part of the restriction.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...