PI uses a combination of SNMP MIB-gathered information as well as the retrieved configuration and correlates it in a local database for presentation and retrieval by the end user as shown n the screenshot you attached. There's no one special MIB that gives you all the information.
Part of the value of an enterprise network management system such as PI is the presentation of that information from disparate sources in a useful manner.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...