cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3675
Views
0
Helpful
2
Replies

Prime Infratructure version 3.0 SNMPV3 c3750V2 issue

bryantsteve
Level 1
Level 1

My PI appliance ver 3.0  fails SNMPV3 authpriv credential verification for C3750V2 FS switches,  SSH CLI  and ping are successful.  I have another c3750V2 FS switch  IOS 15.02.SE10a which the PI appliance can successfully connect and poll SNMPV3. For my C3750V2 FS switches  IOS 15.0.2.SE10a having stacked switches attached to a Master,  using the same SNMP configuration as the stand alone for PI and switch, as I SYNC  or do  Verifying Credentials,  I get the pop up message "Check whether the SNMPV3 credentials are valid" (I believe they are)

 

Here is the switch config being used:

 

snmp-server user <user name> campusgroup v3 auth sha <pass phrase> priv aes 128 <pass phrase> access 12 (ACL 12 permits the PI host)

snmp-server group campusgroup v3 auth read campusview access 12

snmp-server group campusgroup v3 auth context <management VLAN> read campusview access 12

snmp-server view campusview internet included

snmp-server view campusview interfaces included

snmp-server view campusview system included

snmp-server trap-source <management VLAN>

snmp-server enable traps license

 

As best I can determine the only difference is one switch is in a stacked mode the other stand alone 

the stand alone being the switch that works. Any help/suggestions greatly appreciated

 

1 Accepted Solution

Accepted Solutions

bryantsteve
Level 1
Level 1

My  3750V2 stacked switches are now communicating after numerous tries removing and reapplying

snmp-server configs  using a general  no snmp-server  negate command I  instead negated each line and then  reapplied.    Prime then SNMP  discovered and started polling the devices

 

no snmp-server user <user name> campusgroup v3 auth sha <pass phrase> priv aes 128 <pass phrase> access 12 (ACL 12 permits the PI host)

no snmp-server group campusgroup v3 auth read campusview access 12

no snmp-server group campusgroup v3 auth context <management VLAN> read campusview access 12

no snmp-server view campusview internet included

no snmp-server view campusview interfaces included

no snmp-server view campusview system included

no snmp-server trap-source <management VLAN>

no snmp-server enable traps license

!

snmp-server user <user name> campusgroup v3 auth sha <pass phrase> priv aes 128 <pass phrase> access 12 (ACL 12 permits the PI host)

snmp-server group campusgroup v3 auth read campusview access 12

snmp-server group campusgroup v3 auth context <management VLAN> read campusview access 12

snmp-server view campusview internet included

snmp-server view campusview interfaces included

snmp-server view campusview system included

snmp-server trap-source <management VLAN>

snmp-server enable traps license

View solution in original post

2 Replies 2

pieterh
VIP
VIP

is the user in the "snmp-server user....." statement a local user account?

you could enable snmp debugging and monitor the output.

 

bryantsteve
Level 1
Level 1

My  3750V2 stacked switches are now communicating after numerous tries removing and reapplying

snmp-server configs  using a general  no snmp-server  negate command I  instead negated each line and then  reapplied.    Prime then SNMP  discovered and started polling the devices

 

no snmp-server user <user name> campusgroup v3 auth sha <pass phrase> priv aes 128 <pass phrase> access 12 (ACL 12 permits the PI host)

no snmp-server group campusgroup v3 auth read campusview access 12

no snmp-server group campusgroup v3 auth context <management VLAN> read campusview access 12

no snmp-server view campusview internet included

no snmp-server view campusview interfaces included

no snmp-server view campusview system included

no snmp-server trap-source <management VLAN>

no snmp-server enable traps license

!

snmp-server user <user name> campusgroup v3 auth sha <pass phrase> priv aes 128 <pass phrase> access 12 (ACL 12 permits the PI host)

snmp-server group campusgroup v3 auth read campusview access 12

snmp-server group campusgroup v3 auth context <management VLAN> read campusview access 12

snmp-server view campusview internet included

snmp-server view campusview interfaces included

snmp-server view campusview system included

snmp-server trap-source <management VLAN>

snmp-server enable traps license

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: