I have noticed, that Prime LMS 4.2.2 opened a lot of sessions on a 65k, after some ports to some 3560 went down. So you are not able to connect to the 65k until the sessiontimer times out.
Our access switches (3560) are connected to two 6500 (no VSS) in a V-shape. When I disable e.t. the links to three 3560 on one 65k, it takes 3-5 minutes until Prime has opened a lot of session so that all vtys are busy and I have to wait for the sessiontimer to time out until I can log on to the 65k.
Has someone an idea what is going on here or how I can figure out which job opens so many sessions?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...