Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Prioritizing UDP Traffic

Good day

I am struggling to improve the voice quality over a point to point link. I have 2 asterisk servers which are connected with a 256k link between office A and B. The moment when the line gets busy the voice quality gets very bad.

I enabled ip header compression on both the routers and I would like to give high priority to UDP traffic.

I used the following commands , this is on a 1701 CISCO router running ver12.1

For Header compression:

ip tcp header-compression iphc-format

ip rtp header-compression iphc-format

ip rtp compression-connections 100

I used the follolwing commands to prioritize UDP traffic;

R1(config)#priority-list 1 default low

R1(config)#priority-list 1 UDP high

The router does not seem to support this line. I would appreciate any assistance regarding the correct commands for traffic prioritization. I am not sure if this is the correct way to do this either.

Any help would be highly appreciated

1 REPLY

Re: Prioritizing UDP Traffic

Here's a link on how to configure QoS on 12.1.

http://www.cisco.com/en/US/docs/ios/12_1/qos/configuration/guide/qos_c.html

Hope that helps.

603
Views
0
Helpful
1
Replies