I have charged 21 catalyst 6513 on QPM software and i have followed the user guide step, but when i create a report (Historical/real time) i can't see the interfaces of the switch. Is it a problem of configuration on the switch or is it a QPM problem? The version of QPM that I have installed is 3.2 with patch 3.2.1 - 3.2.2 - 3.2.3
If QPM does not run after installation, or if unusual exceptions occur or error windows are displayed while running QPM, you can obtain system status information from the QPM server, and send the diagnostics results to a TAC representative.
You can run the QPM Diagnostic Tool, which generates a report in a browser window of the system status with its diagnostics and suggests possible solutions where applicable. To send the diagnostics results to a TAC representative, you can run the MDCSupport utility, which collects configuration and system information in a zip file, called MDCSupportInformation.zip.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...