Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problems in snmpwalk when updating from LMS 2.6 to LMS 3.0.1

Hi,

I have upgraded an LMS from 2.6 to 3.0.1. When I try to launch an snmowalk from command line I get this message:

ld.so.1: snmpwalk: fatal: libnetsnmp.so.10: open failed: No such file or directory

Killed

And in Device Center, the third column (that in which "Check Device Credentials" is shown) doesn't appear.

Can anyone please help me?

Regards.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Problems in snmpwalk when updating from LMS 2.6 to LMS 3.0.1

This is bug CSCsl00042. A patch is available at http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-cd-one .

1 REPLY
Cisco Employee

Re: Problems in snmpwalk when updating from LMS 2.6 to LMS 3.0.1

This is bug CSCsl00042. A patch is available at http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-cd-one .

137
Views
0
Helpful
1
Replies