I stopped daemon manager, then initiialized dfmInv and dfmEpm DBs with no problem. However, when I get to dfmFh I hit a wall. I issue the command to reinitialize and get no response. I have issued it twice. The first time I waited about 10 minutes then hit ctrl-C to cancel out. Now I have been waiting at least a half hour and still nothing. I haven't even received the Do you want to continue [y/n]? prompt.
Here is the command I used from within the NMSROOT\bin directory:
Ok hard to admit this on a public forum, but I didn't precede the command with "perl". My excuse is that on other platforms I typically associate the .pl extension with perl.exe, so I am somewhat in the habit of not doing that.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...