Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Problems with configuring netflow

I'm trying to setup up netflow to export to a collection server, but I don't see any traffic coming from the router in question to the collection server, nor do I see the flow information on the router itself when i use show ip flow cache. Any ideas on what I might be doing wrong? I'm using the defaults for this initial configuration.

3 REPLIES
Bronze

Re: Problems with configuring netflow

What kind of device?

What is the actual config on the device?

New Member

Re: Problems with configuring netflow

It's a 3845. The config is attached.

Bronze

Re: Problems with configuring netflow

Hello,

set the following:

on interfaces serial0/0/0, GigabitEthernet0/0, GigabitEthernet0/1 set: ip flow ingress

or ip flow route-cache

I think that it helps. Set also flow export timers: ip flow-cache timeout active + inactive

I recommend set inactive to 30 sec and active to 1-3 minute...

Kind regards,

Jan Nejman

Caligare Co.

http://www.caligare.com

185
Views
0
Helpful
3
Replies
CreatePlease to create content