cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
505
Views
0
Helpful
1
Replies

Problems with Logging debug from a source port

I have a Cisco ASR 1001.  I am trying to send traffic from g0 to a switch that picks up all my logging traffic.

Below is my config.  What am I missing.  I am trying to send traffic to device 10.10.23.17. I want to make sure that ll traffic get to 10.10.23.17.

Thanks in advance!

logging trap debugging

logging facility local1

logging host 10.10.23.17

ip route vrf Mgmt-intf 0.0.0.0 0.0.0.0 10.10.88.1

1 Reply 1

Rolf Fischer
Level 9
Level 9
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco