Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

procedure of putting MIB in cisco switches !!!!!!!!

Hi,

I want to generate below traps and for that i need to put a particular mib RADIUS-AUTH-CLIENT-MIB on the switch. Can anyone tell me the procedure of putting mib directly on cisco switch.

RADIUS: Received from id 1645/167 10.1.10.6:1812, Access-Reject, len 44

Regards,

Ahsan Khan.

2 REPLIES

procedure of putting MIB in cisco switches !!!!!!!!

it is not possible to compile or "put" a MIB file into a Cisco switch.

The supported MIBs are compiled within the IOS. Have a look here to see which IOS supports which MIBs:

http://tools.cisco.com/ITDIT/MIBS/MainServlet

http://tools.cisco.com/ITDIT/MIBS/servlet/index

New Member

Hi Ahsan, make sure to

Hi Ahsan,

 

make sure to correctly understand how SNMP works.

 

- A SNMP-Agent (e.g. located on a Cisco switch) is able to send SNMP-Traps being configured.
  (Available traps are hardcoded in the agent)

- A MIB is simply a (virtual) description of available variables and traps

- Each Agent has its own set of supported MIB-Variables ( use #show snmp mib for getting an
  overview of supported Vars on that switch)

  Please have a look at MIB Navigator on cisco.com (http://tools.cisco.com/ITDIT/MIBS/MainServlet )

- You primary 'install' MIBs on the SNMP-Manager getting access to the hardcoded SNMP-Variables
   and to display SNMP-Agent-Traps correctly

 

Hope this helps

 

Lothar

282
Views
0
Helpful
2
Replies