Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Process DeviceDiscovery Fail to run

I install LMS 2.5 on a windows 2003

I install all SP2 for CS, CM, RME, DFM.

After the Install, the server works fine.

I run an discovery device this morning an LMS discovery state are in Running state since 5 hours.

I reboot the server an after reboot it the discovery is always in dicovery state. Why? ?

The device discovery process, are in stop state.

I restart it, but this process is in state "Run fail" with an error message find next.

DeviceDiscovery Failed to run 0 -2 1073741822 N/A 30/11/2005 15:17:00

Have you any answer about this problem?

I reboot the server again, an I have the same problem

Please help!!!

Thanks

Hervé

2 REPLIES
Red

Re: Process DeviceDiscovery Fail to run

You may be running into CSCsb21408:

LMS 2.5 Device Discovery remains stuck - does not go to Idle

New Member

Re: Process DeviceDiscovery Fail to run

I have open a case and I receive the fix patch

Thanks

131
Views
0
Helpful
2
Replies
CreatePlease to create content