Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Purging all data in LMS 2.6

is it possible to erase all database entries and start from scratch or

should I do a re-install of my existing LMS 2.6 and start fresh.

I started without a clear idea of what I was going to do and now I have a clear idea

but a system that is in a bit of a mess

1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: Purging all data in LMS 2.6

Yes, check out the dbRestoreOrig utility described at the URL below.

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0/user/guide/appc.html

For example, to reset RME data to the default: /opt/CSCOpx/bin/perl /opt/CSCOpx/bin/dbRestoreOrig.pl dsn=rmeng dmprefix=RME

However, I'd certainly entertain the option of reinstalling LMS 2.6 as well.

2 REPLIES
Blue

Re: Purging all data in LMS 2.6

Yes, check out the dbRestoreOrig utility described at the URL below.

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_resource_manager_essentials/4.0/user/guide/appc.html

For example, to reset RME data to the default: /opt/CSCOpx/bin/perl /opt/CSCOpx/bin/dbRestoreOrig.pl dsn=rmeng dmprefix=RME

However, I'd certainly entertain the option of reinstalling LMS 2.6 as well.

New Member

Re: Purging all data in LMS 2.6

That actually did the job quite well, some bits I had to go in adjust later

but the system is in a better state then previously

thanks

142
Views
0
Helpful
2
Replies
CreatePlease to create content