I have a need to assign priority to some non-VoIP traffic based on IP address for a few ports on my Cat3550, which works at layer2. All other packets should not be dropped. Maybe by deviding the bandwith of link, or by some other manner.
And one more. The same problem on 2611 router's serial port.
Is it possible at all, and if so, how can I do this?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...