QPM 4.1 - Real Time Charts not working - HTTP Error 2032
I just installed QPM 4.1 on an LMS 3.1 system. The install went fine with no errors, etc..
I imported all DCR devices into QPM with no problems and imported some existing QOS policies. I am however unable to view either of the real time charts (under QOS monitoring and Baseline monitoring) - the charts load initially and then I get the following error message continually:
Re: QPM 4.1 - Real Time Charts not working - HTTP Error 2032
I don't think so. The bug you mentioned is junked (only found in beta when upgrading from beta 1 to beta 2), and if you look, the URL QPM is trying to access is an SSL URL using the HTTP protocol. In looking at some of the JSP included with QPM, there are quite a few hard-coded instances of http://. I've expressed this internally, and the QPM developers are going to have a look.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...