I'm getting ready for a QPM deployment and I have come across some issues in testing.
I have an Ethernet interface which I need to apply a shaper so I can limit the egress traffic sent to our WAN provider. Then do CB queuing under the shaper.
It looks like I do this via nested polices, but the documentation isn't too clear on how I use the nested policy I create. I think the policies in the nested policies would be the children policies, but it's not really clear. Does anyone have any experience with this?
Also when I attempt to create a shaper it will not allow me to enter a CIR above 154400Kbps and I need a shaper for 200000Kbps. Is there a setting somewhere to increase the limit?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...