Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

query on Alert/activity in LMS

Hi Team

I have few questions on NMS functionality.

I would like to receive Alerts / Notifications when below incidents happen.

1. A Duplicate IP Address comes into Network

2. VLAN flapping.

3. A Major STP Changes.

4. When routing change happens

Kindly advice on the same could be configure the same on LMS.



Cisco Employee

Re: query on Alert/activity in LMS

The first three can happen simply by managing your devices in DFM, and configuring them to send traps to DFM. DFM has a built-in duplicate IP event, and will send events for interface flapping and STP changes provided device traps are configured.

The final event can be handled by sending syslog messages to RME. You can then configure a syslog automated action to send you email when routing-based syslog messages are received. Syslog automated actions can be configured under RME > Tools > Syslog > Automated Actions.

New Member

Re: query on Alert/activity in LMS

Hi Clarke

we have configured the same..but we are not getting mails for DUPLICATE IP ADDRESS.

we are able to see the alerts on LMS but not gettin alerts on mail for duplicate address..

Kindly provide the solution for the same.

Thanks & Regrads


Cisco Employee

Re: query on Alert/activity in LMS

You need to configure a Notification Group as well as an Email Notification Subscription under DFM > Notification Services in order to receive email. If you choose to create an Event Set so that you only get emails on duplicate IP addresses, add the "Duplicate" event to your Event Set, then only check the following boxes in your Notification Group:

Event Severity:



Event Status: