Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Question about allowing router configuration only through loopback interface

Hi all,

Hope I'm asking my question in the correct place - 

I wish to allow to configure my router only through a specific loopback interface I've created.

Is there a way to block all other interfaces of the router for configuration purposes, without shutting them?

 

Regards,

Shaked.

 

P.S

If this is not the place for my question - I would be very pleased if you could direct me to the correct place... (I'm a noob)

1 REPLY

Take a look at the posting

Take a look at the posting below.

 

https://supportforums.cisco.com/discussion/10737776/restricting-telnetssh-access-loopback-address

 

hope this helps

please rate helpful posts

thanks

34
Views
5
Helpful
1
Replies
CreatePlease to create content