Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Question about portOperStatus.2.1 output

MIB CISCO-STACK-MIB

Name portOperStatus.2.1

iso.org.dod.internet.private.enterprises.cisco.workgroup.ciscoStackMIB.portGrp.portTable.portEntry.portOperStatus.2.1

OID 1.3.6.1.4.1.9.5.1.4.1.1.6.2.1

Type INTEGER

Units

Access read-only

Status unknown

Value minorFault(3)

The current operational status of the port.

Possible Values :

down(-1)

other(1)

ok(2)

minorFault(3)

majorFault(4)

fullDuplex-10Mb(5)

fullDuplex-100Mb(6)

autoNego-failed(7)

halfDuplex-1000Mb(8)

fullDuplex-1000Mb(9)

Obviously some of these possible values are self explanatory.

But, what is a minor fault vs. a major fault?

Does ok mean everything is fine?

What does "other" mean?

Thanks,

Bob

  • Network Management
3 REPLIES
Cisco Employee

Re: Question about portOperStatus.2.1 output

A state of minorFault is not good. Check portAdditionalOperStatus for more of a clue as to why that may be.

Other could mean anything, really. It usually points to a gap between device and MIB instrumentation.

New Member

Re: Question about portOperStatus.2.1 output

Ok, thanks.

On our 6513 Catalyst - IOS (tm) s72033_rp Software (s72033_rp-ADVIPSERVICESK9_WAN-M), Version 12.2(18)SXF7, RELEASE SOFTWARE (fc1)

portAdditionalOperStatus shows as an "unsupported OID"

Cisco Employee

Re: Question about portOperStatus.2.1 output

This object is typically a CatOS object. You can try running "show int status" on the switch to see if that command gives you more specific details as to the real state of the port.

209
Views
8
Helpful
3
Replies