Hi, We are running LMS 3.2 (windows) and I have a group of switches I am trying to monitior in DFM.
I have discovered the devices in device management successfully. Then I import the devices into DFM they always go into a questioned state.
Several attempts with the same results have been tried.
I checked in MARS and I see denies from my LMS server to the devices Im trying to import to DFM. The traffic seems to be in relation to when Im attemping the imports to DFM. The denies are on UDP-137. Is this port needed from LMS to the device for DFM to discover and monitor it ???
I have increased the SNMP Timeout to 14 seconds 3 retries
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...