cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
483
Views
0
Helpful
4
Replies

Questioned Devices

justserve
Level 1
Level 1

Hello All,

I have some devices in DFM that initally were discovered and their status was KNOWN. But they have all gone into QUESTIONED state. Attempts to re-discover the devices didn't make them KNOWN.

Checking the information about these devices show:

1.   Devices in OTHERS

     *** Data Collector Status Information ***
     Error Code                   = Others
     Error Message             = DataCollector request timeout(internal problem)

2. Devices in SNMP Timeout

     

       *** Data Collector Status Information ***
        Error Code                   = Snmp Timeout
        Error Message             = N/A

What should I do so that the status of the devices can become KNOWN.

Sincere regards.

4 Replies 4

Joe Clarke
Cisco Employee
Cisco Employee

What version of DFM are you using?

The version of DFM is 3.0.5 while the LMS is 3.0.1 with CS version 3.1.1

The problem with devices slipping into Questioned (especially with internal errors) should have been fixed in 3.0.5.  However, the SNMP timeout good point to another problem.  What version of SNMP are you using with these devices?

The version of SNMP is v2C

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco