This may be a rather elementary question but I have been unable to find a direct answer to this. Is there an OID to access on a 6500/2800/3800 series IOS device to view the routing table (BGP/EIGRP/STATIC)? I'm looking for a way to dump a full routing table in order to gauge how our dynamic routing is handling load balancing. The only way I can do it now is to manually query each individual route, thus requiring me to add every route to the SNMP query. Is it possible to return the full routing table without the need of this manual 1-by-1 checking? Thanks in advance!
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...