Not sure if this is even the right forum for this but ill go ahead and post anyways.
Basically I need to get some "show outputs" of about 100+ Cisco switches (The same model and IOS version). Now, I can do the task manually but I was wondering if there was an easier way of doing this... like script perhaps? I know there are a few tools that can do this like "Kiwi Cat tools" but I would like something free or something I can do on my own. However we are using CiscoWorks but no one here is really knows how to use it in it's full potential. Is there a way to do this in CiscoWorks?
Also, can anyone point me to a good CiscoWorks documentation/user guide?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...