One of my customer is having reliance 2mps link through this they r sending the bandwidth to his remote branches through 64kbps leased lines.Now the problem is reliance people is saying my customer is using compleet 2mbps but if i down load some file my customer is not able to get that 2mb speed .So band width utilisation is more.How can i found this.For this any tool is there to see how much bandwidth is going to each pc and remote branches also.Plz help me how can i resolve this issue.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...