I have 4 remotes sites with cisco 1841 ADV SEC and one HQ site with ASA 5510.VPN is implemented over radio link.Every site also have a backup adsl connection so i configured reliable static routing on the spokes as well as the hub so that when the radio link goes down the adsl link comes up.It seems to be working.
My question is that should Reliable static routing be configured also on the main site ?
The docs i have read mention configuring it on spokes sites only.
If that is the case how should routing be configured on the main site ?
A documentation illustrating the config for the hub site will be highly appreciated.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...