Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

reload a cisco router via snmp

Hi,

I am trying to reload a cisco router via SNMP. snmp-server system-shutdown is enabled on the router. I run the snmp get and it says message done but than nothing happens. What else is missing?

Thanks

Mary

[odriscm2@nmsorcnnm02 odriscm2/] $ snmpget -c w2e37uh1 10.70.8.5 .1.3.6.1.4.1.9.2.9.9.0

cisco.local.lts.tsMsgSend.0 : INTEGER: messagedone

[odriscm2@nmsorcnnm02 odriscm2/] $

1 REPLY
Cisco Employee

Re: reload a cisco router via snmp

What was the SNMP Set command you used to set tsMsgSend? What version of IOS is running on this device?

1179
Views
0
Helpful
1
Replies
CreatePlease to create content