So I set up a PIX 506 for a remote office to be their VPN endpoint, connecting to my CVPN 3000 series box at the head office. I've tested it, and traffic is passing properly. However I just can't for the life of me figure out what I need to do to configure SSH management of that unit OVER THE VPN from the head office. I've set up SSH, and can SSH in from the LAN behind the PIX, but not from the other end of the VPN. Any thoughts? Can I even do this? The PIX is running 6.3 software.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...