Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

replacing a AS2509-RJ ?

Hi,

We have a number of sites using an old combination of a cisco AS2509-RJ router, a dialup modem and a APC 9211.

this combination allows us to dialin and access network devices (switches, routers, etc) should we loose our LAN connection or screw up during a config, and the APC to reboot devices.

I cant seem to find anything within the cisco family to replace the 2509.

can anyone recommend a valid replacement, or perhaps an "all in one" solution to do what we need?

2 REPLIES
Silver

Re: replacing a AS2509-RJ ?

check out the following link for a list of access servers available, hope this helps :

http://www.cisco.com/en/US/products/hw/iad/tsd_products_support_category_home.html

Re: replacing a AS2509-RJ ?

Hi,

There's no exact replacement for a 2509 as the functionality is replaced by either network modules or wics/hwics.

Cheapest option is probably an 1841 with a combination of an HWIC-8A (for 8 async ports) and a WIC-1AM (for the modem). However, if you use the 2 sync serial ports in the 2509 you'll be stuck - and a 2800 might be a better choice.

Here's the link for async NM's:

http://www.cisco.com/en/US/products/hw/routers/ps259/products_data_sheet09186a0080091b8b.html

and here's the link for the HWIC's:

http://www.cisco.com/en/US/products/ps5949/products_data_sheet0900aecd80274416.html

HTH - plz rate if useful.

Andrew.

334
Views
0
Helpful
2
Replies