Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

restarting RME

is there any other way other than stop/start dmgtd to restart RME? when I do sync archive the job keep staying on pending state for hours. I have tried on 405 different devices but still the job is hanging, do i need restart dmgtd or I can restart some process?

Thanks,

7 REPLIES
Cisco Employee

Re: restarting RME

You can restart ConfigMgmtServer alone, but the problem will most likely come back. There are quite a few known bugs with config archive locking up in LMS 3.1. I suggest you move to LMS 3.2 to get the fixes for all of them.

To restart ConfigMgmtServer, run:

pdterm ConfigMgmtServer

pdexec ConfigMgmtServer

New Member

Re: restarting RME

thanks, actually we have 3.2 and the issue is on going since we have installed 3.2.

I have attached dcrclent.log

These are repeating in the dcrclient.log. We have verified we do NOT have any debugging enabled, but for some reason these lines just keep repeating every 2 or 3 seconds.

There are 4 distinct threads shown here. These might be a side-effect of the real cause, not real sure.

Cisco Employee

Re: restarting RME

These messages (and anything in DCR) have nothing to do with config archive operations locking up. In order to analyze that, you will need to open a TAC service request when the problem is occurring. Then, a full thread dump can be captured for ConfigMgmtServer, and it can be analyzed to see why the operations are locking up.

As for the DCR debugging, check NMSROOT/lib/classpath/com/cisco/nm/dcr/log4j-dcrclient1.properties,log4j-dcr.properties, and log4j-dcrclient.properties, and make sure there are no instances of DEBUG in these files. If there are, change them to FATAL, then restart Daemon Manager.

New Member

Re: restarting RME

thank J. can you tell me how to do "full thread dump can be captured for ConfigMgmtServe " to submit to TAC. also I need to do this job while running archive job, am I correct?

Cisco Employee

Re: restarting RME

This is not a simple process. TAC can walk you through the steps.

New Member

Re: restarting RME

ok. thanks!!

Cisco Employee

Re: restarting RME

362
Views
0
Helpful
7
Replies