Restoring backup of lms 3.0 after upgrading to 3.1
I am going to upgrade lms 3.0.1 to 3.1.
I have the backup file which is backed up long back from 3.0.1.
Can I restore the same after I upgrade it to 3.1 Also I would like to know as we have some issue with the backup not happening at present so we are going to uninstall & install lms 3.0 from scratch & upgrade to 3.1.
If the backup taken from 3.0.1 can be restored to 3.1 can anybody pls guide me the process how to do the same.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...