Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

retrieving bgp peers via snmp

Hi all, I used to monitor bgp peer states in a cisco 7600 configured for VRF using snmp.

I used the 'bgpPeerState' MIB and the output was the full set of configured BGP peers.

Now I upgraded the IOS to 12.2(33)SRB1 and the same MIB give me no answer.

Anyone else tried this before?

Thank you in advance.

Denis

6 REPLIES
Cisco Employee

Re: retrieving bgp peers via snmp

I haven't seen any problems with this MIB in this code...can you post your snmpwalk output here?

New Member

Re: retrieving bgp peers via snmp

sure, I got:

SNMPv2-SMI::mib-2.15.3.1.1 = No Such Instance currently exists at this OID

Cisco Employee

Re: retrieving bgp peers via snmp

How are you actually performing the walk? Can you send your syntax?

New Member

Re: retrieving bgp peers via snmp

snmpwalk -v2c -c 'removed' routername .1.3.6.1.2.1.15.3.1.1

Cisco Employee

Re: retrieving bgp peers via snmp

You might want to open a TAC SR. Make sure to include a show tech from the device and the snmpwalk output. Also, if you have output from a working code it would also be useful

New Member

Re: retrieving bgp peers via snmp

I have the same problem, I've upgraded my 3825 from 12.4.10 to 12.4.18 and OID 1.3.6.1.2.1.15.3.1.2 (bgppeerstate) disappeared.

609
Views
0
Helpful
6
Replies