Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RME 4.2 / configuration compare problem

RME always flag the parameters associated with the

banner and all parameters that follows it as a delta between 2 images.

Any clue ?

2 REPLIES
Blue

Re: RME 4.2 / configuration compare problem

Could be due to CSCsu99748

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCsu99748

CSCsu99748 Bug Details

Out of sync on banner when running config fetched by TFTP
Symptom:

Device marked as out of sync even though show start and show run are the same. The diff viewer shows that the difference for the configs are due to multiline banners for "banner exec" and "banner login"

Conditions:

Appears to affect LMS 3.1 only - LMS 3.0.1 and LMS 2.6 have been observed to be unaffected.

Latest running config is fetched using TFTP protocol. Telnet and SSH not affected.

Banners configured for "banner exec" and "banner login". For example:

banner exec "
*****************************TEST*******************************
"
banner login "
*****************************TEST*******************************
"

Workaround:

Use telnet or SSH to do fetch the running config instead.
Or, use the exclusion commands to exclude all banner config if the banner is not a necessary config to be monitored.
Status
Fixed

Severity
3 - moderate


Last Modified
In Last Year

Product
CiscoWorks Resource Manager Essentials

Technology


1st Found-In
4.2

Fixed-In
4.2
4.3

Cisco Employee

Re: RME 4.2 / configuration compare problem

Yes, this is the bug.  It is fixed in LMS 3.2/RME 4.3.

186
Views
10
Helpful
2
Replies
CreatePlease to create content