RME 4.3.1 - No inventory collection of some 65xx devices
my problem is, that LMS3.2 with RME 4.3.1 does not make an inventory of some 65xx devices. What I've tried so far to correct this problem:
# read the other incidents regarding this problem
# increased the RME device attribute "SNMP timeout" from 2s to 10s -> no success
# increased SNMP timeout for one device (192.168.90.7) from 10 to 20s and the retries from 2 to 3 -> no success
What I've observed:
# no credential problem (I can backup the configs)
# no SNMP problem (I can snmpwalk through the device)
# Inventory collection takes always only app. 10s until the above error unless I've increased SNMP timeout and retries
# IC_Server.log generates always following error:
[ Tue Dec 15 12:22:59 CET 2009 ],ERROR,[Thread-21],com.cisco.nm.rmeng.inventory.ics.core.CollectionController,729,Exception for device 192.168.90.7 is java.lang.reflect.InvocationTargetException at sun.reflect.GeneratedMethodAccessor12.invoke(Unknown Source) at sun.reflect.DelegatingMethodAccessorImpl.invoke(DelegatingMethodAccessorImpl.java:25) at java.lang.reflect.Method.invoke(Method.java:585) at com.cisco.nm.rmeng.inventory.ics.core.CollectionController.run(CollectionController.java:719) at java.lang.Thread.run(Thread.java:595) Caused by: java.lang.NumberFormatException: EPLOYMENT RELEASE SOFTWARE (fc1) TAC Support: http://www.cisco.com/tac ...
Seems if RME has a problem with this special IOS version.
Enclosed you will find the complete IC_Server.log and the screenshot from the inventory collection of 192.168.90.7.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...