Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RME and NAMs

I've added all of our NAM devices into the DCR and the inventory recognises them as WS-SVC-NAM-2 however it won't do a sync archive.

We are running RME 4.0.5 and CS 3.0.5.

The NAMS are running software ver:3.5(1)

and 3.4(1a).

I've also turned on exsession at the cmd line. The username and password are set, I have not set the enable. SNMP READ and READ WRITE are ok.??

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: RME and NAMs

What error do you get trying to sync archive on the 3.4 NAMs? If you perform a sniffer trace while syncing archive, what errors or problems do you see in the telnet session?

Note: NAMs running 3.5 will fail until you upgrade to RME 4.0.6 due to CSCsh27562. However, the 3.4 NAMs should be working.

1 REPLY
Cisco Employee

Re: RME and NAMs

What error do you get trying to sync archive on the 3.4 NAMs? If you perform a sniffer trace while syncing archive, what errors or problems do you see in the telnet session?

Note: NAMs running 3.5 will fail until you upgrade to RME 4.0.6 due to CSCsh27562. However, the 3.4 NAMs should be working.

113
Views
0
Helpful
1
Replies