I believe that RME uses telnet or ssh according to which you have configured in Common Services. This is according to the RME User Guide Chapter 8 which states, in part: "The configuration archive uses Telnet/SSH to gather the module configurations of Catalyst 5000 family devices and vlan.dat file in case of Catalyst IOS switches"
To specify your preferred transport protocol, go to Common Services > Device and Credentials > Device Management and add the protocols such as ssh that you wish to use. Make sure that your device(s) are configured to use the alternative protocol.
Currently, there is no way to use a protocol other than TFTP to fetch the vlan.dat. However, I have just filed an enhancement request to add both SCP and RCP support, and work is already underway to implement that for the release following LMS 3.2. The bug is CSCsz66704.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...