Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

RME - Change Audit window

In RME change Audit Window there is a Message column. when I click on CONFIG_CHANGE title I get the following message.

DCMA0055: CM0036: The configuration file cannot be displayed as this could be a binary file.

Any ideas?

tony

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: RME - Change Audit window

Known issue for vlan.dat (VLAN) config changes. You cannot view the changes in this file. You can disable tracking the vlan.dat file for changes by checking the "Enable vlan Change Audit Filter" box under RME > Admin > Change Audit > Config Change Filter.

1 REPLY
Cisco Employee

Re: RME - Change Audit window

Known issue for vlan.dat (VLAN) config changes. You cannot view the changes in this file. You can disable tracking the vlan.dat file for changes by checking the "Enable vlan Change Audit Filter" box under RME > Admin > Change Audit > Config Change Filter.

130
Views
0
Helpful
1
Replies
CreatePlease to create content