I can use the logon account to telnet/ssh to the device, but why does the log says it could not detect telnet/ssh?
Cat1-6509 VLAN RUNNING Dec 29 2009 19:54:04 Could not detect SSH protocols running on the device TELNET: Failed to establish TELNET connection to 10.172.x.x - Cause: Authentication failed on device 3 times. Cat2-6509 PRIMARY RUNNING Dec 29 2009 19:53:45 Could not detect SSH protocols running on the device TELNET: Failed to establish TELNET connection to 10.172.x.x - Cause: Authentication failed on device 3 times.
RME cannot connect to the device using the credentials in DCR. Export the credentials from Common Services > Device and Credentials > Device Management, and verify you can connect to the device and become enabled using those credentials. If you can, then start a sniffer trace filtering on all telnet traffic to the device in question, and run a new sync archive job. When it fails, post the capture file.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...