I'm building CiscoWorks from scratch with no previous experience (fun). I've gotten through the Device Discovery and I have everything looking good there. I'm trying to setup weekly backups of the switch configs and all of them fail. It is set to use SSH\Telnet. I can SSH to all of the devices with no problem. The failed list all seems to point to authentication errors. Is there somewhere in config mgmt to set authentication parameters or community string values? All of that is in the DCR so I wouldn't think so, but what do I know? RME version is 4.3.2
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...