Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

RME Config editor problem

Im using a fairly old version of RME (3.4) and am experiencing problems when trying to edit configs of any switch using config editor.

I can get into config editor, but when i attempt to select a device to edit its config, i get the error:

"Unable to retrieve message from catalog for message ID 1

Message catalog is null"

Then i if i try another switch , the same error appears but with a message ID of 5.

This is on a Solaris 8 box.

Anyone come across this problem before? Ive tried searching through the forums and on the site but come up empty.

8 REPLIES
Red

Re: RME Config editor problem

Try these steps:

log out of CiscoWorks

cd /opt/CSCOpx/bin

./pdterm JRunProxyServer

./pdexec JRunProxyServer

Log back in to CiscoWorks and see if the issue is resolved

New Member

Re: RME Config editor problem

The server has been rebooted and it still happens. Presumably a reboot would have the same effect as stopping and restarting the process?

I will try it when back at work tomorrow and let you know if i have any further problems.

Thanks

Nick

New Member

Re: RME Config editor problem

I tried the above steps but the same error occured. Is there any properties file i can check for path names or anything i can do to reset the config editor settings without completely reinstalling RME?

Anything else really?

Red

Re: RME Config editor problem

Was the server name change by any chance?

New Member

Re: RME Config editor problem

The server name hasnt ever changed as far as i can see but ive only been looking after the box recently so its a possibility.

Is there a resolution should the name have changed?

Red

Re: RME Config editor problem

uname -a will give you the hostame

check the /opt/CSCOpx/lib/classpath/md.properties files

there is an entry in it called PX_HOST

does it match the hostname?

New Member

Re: RME Config editor problem

Yup. The hostname shown in uname does match the one held in the file.

anything else to try?

Red

Re: RME Config editor problem

Try (re-)installing the latest IDU and see if it resolves the issue

That would be RME 3.4 IDU 4.0:

http://www.cisco.com/cgi-bin/tablebuild.pl/cw2000-rme

122
Views
0
Helpful
8
Replies
CreatePlease to create content