Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RME Device Credential Verification Report

I have a Device Credential Verification Job which runs each week. It has run fine for the last few months, however, this week the job started but didn't finish and appears to have hung.

The job usually takes around 25mins to run (circa 350 devices) but this week it was still running after 19 hours. Eventually I tried to stop the job but it is now stuck in a state of "Stop Initiating".

I've stopped/started the services and evenutallty even rebooted server but this particular job remains stuck in "Stop Initiating" state.

Is there any way to fix this?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: RME Device Credential Verification Report

What version of LMS?  What protocols are you validating in the job?

2 REPLIES
Cisco Employee

Re: RME Device Credential Verification Report

What version of LMS?  What protocols are you validating in the job?

Community Member

Re: RME Device Credential Verification Report

Hi Joe,


LMS3.2.

The job is validating SNMP/v2c Read & Write, Telnet and Telnet Enable.

395
Views
0
Helpful
2
Replies
CreatePlease to create content