Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RME Inventory Collection Device Changes

We are getting a lot of devices on which changes were detected on the Ciscoworks Inventory Collection Job. They indicate that a speed attribute (mbps) has changed such as ifentryid=31 previous value 10000000, current value 100000000. What causes this and is there any way to keep it from reporting or occuring?

1 REPLY
Cisco Employee

Re: RME Inventory Collection Device Changes

If the ports are set to auto-negotiate, any time a new user connects, the speed could change. This attribute can be ignored by going to RME > Admin > Inventory > Inventory Change Filter, then check the box next to Interface > Speed.

127
Views
5
Helpful
1
Replies
CreatePlease to create content