Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

RME /LMS 3.01 Can't discovery 650à Switchs

Hello ,

My customer can't see 6500 switches when he launch a discovery.

The CDP has been enabled on it .The snmp walk OID give:

--------------------------------------------------------------------------------

.1.3.6.1.2.1.1.2

 

RFC1213-MIB::sysObjectID.0 = OID: CISCO-PRODUCTS-MIB::cat6509

 

I have got the 6500's running config tycally set up on the all switches.I added it on the attachements .

Thanks

 

 

 

7 REPLIES
New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

Hmm... if this is a full config (without censor), could it be that he forgot to configure access-list 1?

snmp-server community cisco_read RO 1

snmp-server community cisco_admin RW 1

New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

Ok thanks for the information, i didn't suspect that we could use an access list in SNMP.

I'm gone testing without the field 1 before the RO and RW or adding the Acces list 1 concerned.

Thanks very much.

New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

We have removed the field 1 and the Discovery see the 6500 switch like Unreachable.It has been seen by CDP and the credentials has been verified and Ok ?

So the problem is stil existing ..........

New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

Unreachable usually means there are no snmp response from the switch. When you do discovery, do you put this 6500 switch as the seed device?

Also, check the snmp community configuration for this switch's IP address.

New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

Hello, i have joined the ani.log and the discovery.log.

I will ask to my customer to put the equipement in seed devices.

New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

Hello,

we will do this test.

thanks

New Member

Re: RME /LMS 3.01 Can't discovery 650à Switchs

Dears all,

we made a test under the LMS.

The discovery has been made for a switch configure like a seed device.

The discovery has been relaunched and the switch 6500 /@ip 152.33.100.103 is still unreachable.

126
Views
0
Helpful
7
Replies
CreatePlease to create content