Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RME (LMS 3.2) No detect Change Configuration automatically by Syslog Messages

Hi,

I have a problem with the "change audit" for Syslog messages trigger. I set all my devices to send Syslog messages to the CiscoWorks server. When I make any changes to syslog message is sent correctly for the CiscoWorks server, but it does not start automatically collects configuration (config fetch).

Only when I start manually "sync archive" the configuration is stored and detected the change in configuration.

Has not changed anything in config fetch "to" Automated actions Syslog ".

Thanks

1 REPLY
Silver

Re: RME (LMS 3.2) No detect Change Configuration automatically b

Hi,

You an check RME  > Tools > Syslog > Automated Actions to verify nothing was changed.

Then display 'Config Fetch'. There is contextual help available:

http://:1741/help/rme/fundamentals/index.html?syslog_Defining_Automatd_Actions.html#wp1211314

Nick

267
Views
0
Helpful
1
Replies
CreatePlease to create content