Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RME not using SSH protocol

I am using SSH in a large number of devices but still have the majority on telnet. I cannot get RME to use SSH to do RME jobs.

When I test the SSH devices' credentials from Device Center; they are correct.

I have the SSH protocol in the 2nd position on Config Transport Settings but the SSH devices are still failing.

This is the failure message:

ERROR:RME_CDL1031:Transport session to device failed TELNET: Failed to establish TELNET connection to 10.xxx.x.xx - Cause: connect timed out.

I know it is trying telnet first, and I want it to on the bulk of my devices but how can I get RME to use the SSH transport settings for the ones that I have transitioned to SSH?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: RME not using SSH protocol

This is a CDL error, meaning that this is for config downloading. Make sure that you have set the transport order for the operation you're trying to do (i.e. Archive deploy, Netconfig, or Config Editor).

3 REPLIES
Cisco Employee

Re: RME not using SSH protocol

This is a CDL error, meaning that this is for config downloading. Make sure that you have set the transport order for the operation you're trying to do (i.e. Archive deploy, Netconfig, or Config Editor).

New Member

Re: RME not using SSH protocol

Sorry to respond like rocks but I don't know where to do that. I thought going to Admin>Config Mgmt>Transport Settings was the right place...

New Member

Re: RME not using SSH protocol

I see it! I just saw the drop down box!

148
Views
0
Helpful
3
Replies
CreatePlease login to create content