Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

RME: partially successful devices

I recently updated the devices in CW 3.0.1.

out of 600 devices some 200 are now coming back with the following errors.

Command failedFailed to detect SSH version running on the device. VLAN Config fetch is not supported using TFTP. VLAN Config fetch is not supported using RCP.

None of the devices are running SSH.

1 REPLY
Cisco Employee

Re: RME: partially successful devices

The vlan.dat can only be fetched using telnet or SSH. If RME cannot connect to the device via one of those two protocols, this is the error you would see. Verify the correct username/password and enable password credentials in DCR for these devices.

280
Views
5
Helpful
1
Replies
CreatePlease to create content