Re: RME problem - Unable to retrieve inventory for 3845 router
I applied this patch as directed back in July 2007 but we still get these errors from time to time when we replace a device.
For example, on the weekend we replaced 2 old 6513s with new 6513s - basically the same configs, just an 3 year cycle upgrade (newer Sup, IOS etc). I found that 1 of them is fine in RME, however the other 1 has the RICS0001 error as reported for other device at the start of this thread. One thing different about the failing 1 is that I have added an ACE module to the chassis.
Should I still be getting this problem after the patch was applied?
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...