Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RME "Device Name"

Apologies if this is a stupid question but where do RME Reports get the "Device Name" from? I'm asking because on a few reports I've tried to run, Inventory or Software Versions, I sometimes see either the IP address or the device name. I've even had double entries, one with the IP and one with the name.

Am I missing something obvious?

LMS 3.1 on Windows.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: RME "Device Name"

Device name comes from DCR display name. If you see duplicates, then both entries may be in DCR. However, it would be helpful to see a screenshot to make sure something else isn't going on.

2 REPLIES
Cisco Employee

Re: RME "Device Name"

Device name comes from DCR display name. If you see duplicates, then both entries may be in DCR. However, it would be helpful to see a screenshot to make sure something else isn't going on.

New Member

Re: RME "Device Name"

Cheers Joe, I should've checked DCR, you're absolutely right.

116
Views
0
Helpful
2
Replies